do you have questions
Here at Prime Plumbing we have been servicing the Murrieta area for over 30 years. Our knowledgeable staff are here to help you through even your worst plumbing problems. We pride ourselves on making plumbing civil and friendly. Use us as a resource, ask for a FREE ESTIMATE and know that we will never nickel or dime you or push you into a sale. As Murrieta plumbers we are here to serve the community and, hopefully, give you a wonderful experience while solving your plumbing issues. Below are some frequently asked questions that can build your base of knowledge on what’s going wrong in your plumbing and help to point you in the right direction.
The most common reason most water heaters aren’t working is because the pilot is out. This is usually an easy fix with most standard water heaters. If the pilot won’t stay lit then it’s most likely going to need a new thermal couple. Read More…
This is most likely because your pilot won’t stay lit and you need a new thermal couple. If that doesn’t solve the problem then there might be an issue with your gas valve on the water heater. If your water heater is older than 6 years old, it’s probably time to look for a new water heater rather than paying a plumber to install a gas valve. Read More…
The usual root of the problem is with the pressure regulator. If you have a water pressure gauge you want to hook it up to your hose spikit near the regulator and the pressure should be between 65-70 psi. If the pressure isn’t within this range you need to adjust the regulator. If that doesn’t fix the problem you’ll most likely need to replace the regulator. Contact us and we’ll come out with our water pressure gauge for free to figure out the root of the problem. Read More…
If you have a bad leak that need to be stopped immediately you should shut off the main water supply to the house. This is usually located on the side of your home. If you can’t find the main water supply, contact us and we’ll walk you through the process or come out to help. Read More…
For a wall leak you might constantly hear water running in the walls. For a leak in your slab you might see water puddling in areas where the leak is under the ground. To test if you have a leak, turn off all fixtures in the home (sinks, showers, hoses, etc.). Then go look at the meter on the street and see if the star shaped dial is spinning. If the dial is spinning then you are losing water somewhere and have a leak. Note: Some leaks are so small you don’t see the dial moving. In this case you need to contact us for a free estimate to see if a leak detection is necessary.
If you have a bad leak that need to be stopped immediately you should shut off the main water supply to the house. This is usually located on the side of your home. If you can’t find the main water supply, contact us and we’ll walk you through the process or come out to help.
Prime Plumbing goes above and beyond and takes care of all dry wall repair so that the homeowner doesn’t have to deal with it. If we make a hole, we’re going to professionally patch it. We don’t collect final payment until all drywall repairs have been completed and the customer is 100% satisfied. Read More…
Prime Plumbing serve these areas
Find us in these areas:
- Temecula
- Fallbrok
- Menifee
- Lake Elsinore
- Winchester
- Riverside
For more information go to service areas.
Check the Free Estimate‘s page.